PLEASE GO TO OUR NEW SITE AT

www.Growtronix.com

Add-on Hardware

Add-on Hardware

Display: List / Grid
Show:
Sort By:
Controllable Power Outlets
The Controllable Power Outlets switch on and off the hardware in the growing area. Such as ventilation blowers, pumps, lights, dehumidifiers, fogger/humidifier, water chillers, heaters, fans, or just about any other electrical device.  Each outlet on the unit is independently controllable by..
$98.00
International Controllable Outlets
This unit is the same as our Controllable outlets unit but it has multi-national outlets that can accommodate power plugs from most countries. This allows you to just plug your equipment right in. The power input uses a standard IEC 320 cable. These are widely available for all major count..
$108.00
Temperature Sensor
The Growtronix Temperature sensor allows for precise temperature readings.    Range -17° - 48° C / 0° - 120° F  Accuracy ±0.5° C       Common Uses   Temperature Controller - The software can turn on..
$39.00
10-55mL/minute Dosing Pump
The new dosing pump has been completely redesigned. This pump features a built in controller, so that the unit can plug directly into the Growtronix network. No longer is there a need to have a controllable outlet or a relay module to control the pump. The pump includes a new fail safe feature...
$189.00
CO2 Sensor
The Growtronix CO2 Sensor has a range of 0-5000 PPM. Using the Growtronix CO2 sensor the system can control CO2 levels much better then any other controller because it's control is 100% customizable. It does all of the standard type of control, such as only adding CO2 during lights on and maintain t..
$399.00
Filtered Humidity and VPD Sensor
The Humidity Sensor is a relative humidity (%RH) sensor with on board temperature compensation. It is filtered so that it can be used in condensing environments. In addition to the Humidity reading, the Growtronix software also uses this sensor to calculate the dew point temperature and VPD (Vapor P..
$89.00
Humidity and VPD Sensor
The Humidity Sensor is a relative humidity (%RH) sensor with on board temperature compensation. In addition to the Humidity reading, the Growtronix software also uses this sensor to calculate the dew point temperature and VPD (Vapor Pressure Deficit). As with all Growtronix Sensors, the sensor value..
$79.00
pH Sensor
Monitoring and controlling pH has never been easier! The importance of controlling pH in an indoor garden can't be overstated. The pH of the nutrient solution determines how available the nutrients are to the plants. Too high and several nutrients are unavailable, too low and several other..
$239.00
pH Sensor (No pH Electrode)
Monitoring and controlling pH has never been easier! The importance of controlling pH in an indoor garden can't be overstated. The pH of the nutrient solution determines how available the nutrients are to the plants. Too high and several nutrients are unavailable, too low and several other..
$164.00
TDS/Conductivity and Temperature Sensor
This is our new conductivity and temperature sensor design. The new design allows for the conductivity and pH sensors to be separated.    Conductivity   TDS Scale 0-2000 PPM EC Scales 0-4 mS/cm ; 0-4000 µS/cm ; 0-40CF ..
$249.00
Reservoir / Soil Temperature Sensor
The Reservoir / Soil Temperature Sensor is an epoxy resin sealed waterproof temperature sensor. It can also be used as an outdoor/indoor temperature sensor.   Parameter Value Range -13° C - 85°C / 0°F - 185°F Accuracy ±0.5°C ..
$49.00
Door and Window Sensor
This sensor is fairly self explanatory, It lets the software know whether a door or window is open or closed. It detects this through a standard alarm sensor. The part of the sensor which extends from the unit is attached on one side of the door and the other module (an enclosed magnet) is attach on..
$59.00
Float Sensor - Horizontal Mount
The float sensor allows for monitoring the water/nutrient level of the reservoir and can be utilized in many ways. Anything from total control of a reservoir by using Growtronix Controllable Power Outlets to turn on pumps when the reservoir is low to just a simple text message letting you ..
$59.00
Float Sensor - Vertical Mount
The float sensor allows for monitoring the water/nutrient level of the reservoir and can be utilized in many ways. Anything from total control of a reservoir by using Growtronix Controllable Power Outlets to turn on pumps when the reservoir is low to just a simple text message letting you ..
$59.00
Flood / Leak Detector
The Flood/Leak Detector is a sensor no hydroponic grower should go without. It is capable of detecting 1/16" of water. The Growtronix software can be setup to turn off pumps or close valves and/or send you a email or text message to your cellphone. We have received some great stories of this sensor ..
$59.00
Motion Detector
This sensor allows the Growtronix system to detect motion, it's generally used as part of a personal security system.You can easily setup the system to text message your cellphone if a break in occurs. You can also play a sound file and/or save snapshots from an installed camera.  ..
$59.00
Smoke Detector
The Smoke Detector is a silent photoelectric smoke detector with a Growtronix Interface. The Sensor can be used as a last line of defense against fire. The Growtronix software can be setup to turn off all power to the relays, send a text message and/ or Play a sound file. Important Notice: The sm..
$98.00
Power Injector
The power injector is used to add a fresh power supply for "downstream" sensors and controls to utilize. The power injector adds 750mA of usable power. Most sensors only use approximately 8-15mA each. Exceptions are listed below: pH Sensor : 65mA TDS/Conductivity : 14..
$59.00
Switch Module
The switch module has multiple uses. It allows the software to switch on and off  a 5 VDC signal. Generally they are used to switch on and off a solid state relay. Solid State Relays are used to switch higher amperage loads. The switch modules 5 volt DC output is suitable to control solid s..
$44.00
Dual Power Supply Relay
This unit allows for a low voltage power supply to be switched on and off at it's two outputs. Each output is independantly controllable in the Growtronix software. For example you could plug in a 12v power supply into the input then plug the output into a 12v solenoid valve to be able to control (o..
$85.00
Add-on Network Interface Module (Adds the ability to add 32 more hardware items)
The Add-on Network Interface Module (NIM) can be added to a base system to allow for adding an additional 32 hardware items to the network. This module can only be added to a base system, it can not act as a base system itself. A base system can support up to 15 add-on NIM's. Each NIM itself can sup..
$219.00
Growtronix © 2004-2021