No products
This tubing is resistant against pH up and down and handles nutrients...
The Controllable Power Outlets switch on and off the hardware in the...
The Humidity Sensor is a relative humidity (%RH) and temperature sensor....
Keeping your nutrients and pH levels perfect all the time is one of the...
This unit allows for a low voltage power supply to be switched on and...
Controlling the nutrient solution is one of the most challenging and...
The Growtronix Automation System allows for precision control over every...
The Growtronix Temperature sensor allows for precise temperature readings.
10 Foot unshielded cable. The Growtronix system uses standard cat5e cables. We recommend purchasing from IOFast.com
5 Foot unshielded cable. The Growtronix system uses standard cat5e cables. We recommend purchasing from IOFast.com
The Growtronix Automation System allows for precision control over every aspect of the growing environment. The base system is a starting point, it contains all the essential hardware and software for setting up a basic control system.
This module interfaces an Apogee PAR sensor to the Growtronix system. The readings are output in µmol/(m²s). PAR stands for Photosynthetically Active Radiation. PAR is defined as 400-700 nm (nano meters) this is the color range of light that plants respond to. In other words the Apogee sensors gives you a light reading that directly correlates to light...
This is a high quality double junction replacement pH electrode for the pH Sensor. The probe is fully submersible (excluding the bnc connector) and suitable for constant monitoring.
Connects any standard ORP electrode to the Growtronix system. Range: -1000mV to 1000mVAccuracy: +/- 20mVResolution: 1mV
This is a high quality Conductivity/TDS & Temperature probe for the EC/TDS Module. The probe is fully submersible (excluding the connector) and suitable for constant monitoring.
The 0-10 VDC Variable Output provides an analog output between 0-10 volts DC. It can be used to control dimmable ballasts and lighting that support a 0-10v signal. It can also be used for motor and fan speed control that accept a 0-10v signal.
18V 1.5 Amp Power supply. This is a replacement power supply for a Network Interface Module Important note: This power supply is for the current version of the Network Interface Module. Do not use it with any legacy hardware or with dosing pumps. Damage can occur.
The Growtronix flow sensor allows for measuring the rate of water flow. The reading is displayed in either Gallons per minute (G/Min) or Liters per minute (L/Min).
This is a high quality double junction replacement industrial pH electrode for the pH Sensor. This probe is NOT submersible.